Broward · South Florida
Frigidaire repair in Weston
Planned neighborhoods where whole phases share a specification, so we usually know the unit before we arrive. Most are now well past their original coverage.
We cover Weston and the rest of Broward: an on-site diagnostic first, the price agreed in writing before anything is opened, and the exact figure confirmed once we have seen the unit.
By unit
What we repair in Weston, by Frigidaire unit
Start with whichever matches yours. How an appliance is installed shapes the visit as much as the repair does, which is why we ask about it when you book.
-
Upright · chest · single door Frigidaire freezer repair in Weston
Twenty-seven cabinets, and unusually for a volume brand the upright is the bigger half — 17 against three chest freezers and a small single-door family. In South Florida a standalone freezer usually lives in a garage or a utility room rather than a kitchen, which changes both what goes wrong and what a visit involves: ambient temperature well above what the cabinet was rated for, a condenser breathing dust, and a door that gets opened with wet hands in August. A freezer that is quietly running warm is the failure that costs the most, because nothing announces it until the food is gone.
- 27 cabinets — 17 upright, three chest, the rest single-door
- Most of them live in a garage, at an ambient the cabinet was never rated for
- Running warm is the expensive failure: nothing tells you until the food does
-
In the refrigerator · in the freezer door Frigidaire ice maker repair in Weston
This page is about the ice maker inside the refrigerator, because that is where Frigidaire puts them. The catalog has no undercounter ice cabinet at all — the standalone machines are three countertop appliances, and they have their own page. What we are called out for here is the module in a French door or side-by-side cabinet: no ice, hollow or half-formed cubes, a bin that has frozen into one block, or a dispenser that grinds and delivers nothing. The water side of that circuit — filter, valve, line — causes more of it than the module itself.
- The module inside the refrigerator, which is where this make puts it
- No ice, hollow cubes, a frozen bin and a dispenser that grinds — one circuit, four faces
- The problem is on the water side more often than in the ice maker
-
Countertop · portable · bullet ice Frigidaire ice machine repair in Weston
Three models, all of them countertop: a portable machine you fill from a jug that makes bullet ice in a few minutes. It is worth being exact about that, because the phrase 'ice machine' means an undercounter cabinet with a drain and a condenser on other makes in this trade, and Frigidaire builds none. These are small appliances with a pump, a compressor, an evaporator of steel fingers and a water reservoir, and they fail in small-appliance ways: scale, a pump that has lost prime, a sensor that thinks the basket is full.
- Three countertop machines — this make builds no undercounter ice cabinet
- Bullet ice from a filled reservoir, not a plumbed circuit
- Scale, pump priming and the full-basket sensor cause most of it
-
Beverage centers · wine storage Frigidaire wine cooler repair in Weston
Seven cabinets, and they are beverage centers and wine storage rather than the multi-zone cellars the luxury makes in this fleet sell. They go under a counter or into a bar run, they are usually glass-doored, and in South Florida they spend the year fighting the room: warm ambient, a glass door that gains heat, and a compressor sized for a small cabinet. The complaints follow from that — not holding temperature in the afternoon, condensation on the inside of the glass, a fan that has become loud.
- Seven cabinets — beverage centers and wine storage, not multi-zone cellars
- A glass door in a warm room is the whole thermal problem in one part
- Not holding temperature, condensation and fan noise are the three calls
-
Built-in · front control · plastic and stainless tub Frigidaire dishwasher repair in Weston
Thirty-six machines, from the plain front-control model that fills a builder's kitchen to the Gallery and Professional trims with a third rack. This is the appliance where the difference between series is smallest: the same platform, a different fascia and a quieter tub. What we attend is consistent because of that — not draining, not cleaning, not drying, and water where it should not be. The filter and the spray arms account for more of it than any electrical part does, which is why the first questions are about what is at the bottom of the tub.
- 36 machines across three trims on much the same platform
- Not draining, not cleaning, not drying, leaking — four complaints, one machine
- The filter and the spray arms explain more calls than any board ever does
-
Top load · front load · laundry centers Frigidaire washer repair in Weston
The current catalog carries two top-load washers and three laundry centers, and that thinness is worth saying out loud: Frigidaire's laundry line today is a fraction of its kitchen line. What we open in South Florida is mostly older — front-loaders from the years the badge sold them in volume, top-loaders in condominium closets, and stacked laundry centers in apartments where nothing else fits. The failures are the ones that come with age and with this climate: bearings, seals that never dry, pumps that meet a lint load nobody clears, and drains that back up in a shared stack.
- Nine current laundry machines in the whole catalog — two of them washers
- Most of what we service is older, and stacked centers are normal in condominiums
- Bearings, door seals, pumps and shared drains do the failing here
By job
The repairs we are called out for in Weston
Starting figures for this equipment in South Florida. What moves them is the model, the access and the part — the exact cost is confirmed after the on-site diagnostic.
-
from $165 Dishwasher drying and heat repair
Nothing dry at the end of a cycle, or plastics wet while the china is fine. It is worth knowing that Frigidaire's plainer machines dry by holding heat rather than by blowing air, so damp plastic is close to normal and a dry load is helped more by rinse aid than by any setting. Where nothing at all dries, the heater, the vent flap or the thermostat is genuinely at issue.
- On the plainer machines damp plastic is the design, not a failure
- Rinse aid changes drying more than any button on the panel
- Nothing drying at all is the heater, the vent or the thermostat
-
from $165 Electric cooktop element repair
One zone dead, a zone stuck on full, or a radiant element that cycles far too quickly. On these cooktops the switch and the element fail about equally often, and there is a third candidate nobody thinks of: the receptacle a plug-in element sits in, which burns at the contacts and looks like a dead element from above.
- Element, switch or receptacle — the third one is the one that gets missed
- A zone stuck on full is a switch, and it gets attended to quickly
- Radiant elements are tested cold, not by watching them glow
-
from $129 Dishwasher drain and pump repair
Standing water in the bottom of the tub after every cycle. On these machines the cause is more often something caught than something failed — the filter, the sump, the check valve, or the connection under the sink that a plumber left blocked. We look at those before quoting a pump, and we show you the filter, because on this make it is a two-minute job you can then do yourself.
- The filter and the sump before the pump, always
- The blockage is often under the sink rather than in the machine
- We show you the filter so the call does not repeat
-
from $115 Oven temperature and calibration service
Baking that has gone wrong without anything obviously failing: cakes that sink, a cavity that runs twenty degrees under, a machine that was fine until it was moved. Most of these are the sensor or the calibration, and both are cheap to establish. It is also the visit where we find out that a new oven is behaving correctly and the recipe was written for an old one.
- Cheap to measure and often not a failure at all
- A sensor reading high is the commonest single cause
- Ovens can be offset in software; not every complaint needs a part
-
from $99 Countertop ice machine service
Frigidaire's standalone ice makers are three countertop machines — a reservoir you fill by hand, a pump, a set of chilled fingers and a basket the machine does not keep frozen. They fail in small-appliance ways, and we are straightforward about the economics: scale, a pump or a sensor is worth doing, and a sealed-system failure on a machine of this class usually is not.
- A countertop appliance, not a plumbed cabinet — this badge builds no undercounter machine
- Scale, pump priming and the full-basket sensor cause most of it
- We say when a repair is not worth the money instead of taking it
-
from $119 Dryer vent cleaning
The single most useful thing that can be done to a dryer in South Florida, and the one job here that is a safety matter rather than a convenience. A duct that is long, bent and full of lint makes a healthy machine look broken, doubles cycle times and is a genuine fire risk. In apartment buildings the run is often shared and longer than anybody realizes.
- Doubles cycle times when it is bad, and it is a fire risk when it is worse
- Building runs are long, shared and rarely cleaned
- Measured before and after, so the difference is a number
Nearby
Where else we work near Weston
Every place below has its own page, with what the equipment and the access are like there.
Elsewhere in Broward
In more detail
Frigidaire repair in Weston, in more detail
What Frigidaire equipment is like in Weston
Planned neighborhoods where whole phases share a specification, so we usually know the unit before we arrive. Most are now well past their original coverage.
Weston sits in Broward County, and the equipment here follows the housing: older kitchens with appliances fitted into openings that were cut for something else, and newer ones where they were specified with the cabinetry. Both are Frigidaire work — cooktop, dishwasher, dryer — and both are diagnosed on site before anything is priced.
Heat, dust and power cuts — what they do to a kitchen full of appliances
Inland the enemy is heat, dust and grease rather than salt. Condensers run hard for more months of the year here than almost anywhere else in the country, and grease that condenses in a hood liner instead of leaving through it comes back as a fan that labors. In Weston the appliances we are called out to are usually working exactly as designed — in conditions nobody designed them for.
What that means for the appliances in Weston
- Whole streets here were built to one specification, so we frequently know the model before we arrive and can bring what it usually needs on the first visit.
- Refrigerator making a noise
- Dryer takes two or three cycles
- Small, hollow or cloudy ice
- Oven door locked shut
- Dishwasher not cleaning
How a visit in Weston is arranged
We ask for the model number from the plate inside the door and a line about what the appliance is doing. That decides which parts ride in the van, and it is the difference between one appointment and two.
- How the appliance is built in, and whether it has ever been pulled out before
- Whether there is a second one — a bar, a pantry, a garage or an outdoor kitchen
- Whether the doors are paneled to match the cabinetry, which changes how they come off and go back
- The diagnosis first, then the scope and the price in writing, and your approval before anything is opened
What it costs, and what moves the figure
Prices in Weston are the same as everywhere else we cover: a diagnostic from $89 that is credited toward the repair, and starting figures per job rather than one number for "a repair". What moves it is the model, how the appliance is built into the cabinetry, which part it needs and how quickly that part can be sourced — none of which can be judged over the phone. The repairs we carry out lists what each job involves and the figure it starts at, and the unit pages covers what tends to go wrong on each type.
The exact cost is confirmed after the on-site diagnostic and agreed with you before any work begins. We are an independent repair company — not affiliated with, authorized by, or endorsed by any manufacturer — and our warranty covers the labor we performed.
Before you book
Questions about a visit in Weston
Do you cover Weston?
Yes. Weston is in Broward County and inside the area we work every week. Give us the address when you book, and say how the Frigidaire is installed — what has to come apart to reach it matters as much as where it is.
How soon can you get to Weston?
We will tell you the earliest slot we can genuinely keep rather than the earliest one that sounds good. Tell us the model number and what the unit is doing when you book: whether we can finish the same day depends on the part far more than on the drive.
Does it cost more because the job is in Weston?
No. The diagnostic and the work are priced the same across Miami-Dade, Broward and Palm Beach. What moves the figure is the model, how the unit is built in and which part it needs — never the address. Where access takes longer, we say so before anything is agreed rather than after.
What do you need from me before the visit in Weston?
The model number from the data plate, a photograph of the display if anything is showing on it, and a line about what the unit is doing. Those three decide which parts a technician brings, and they are the difference between one visit and two.
Booking a visit in Weston
Tell us the model number and what the unit is doing. We will bring the parts that problem usually needs, and you will have a firm price before we start.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards