Service
Frigidaire control board repair
The board is the part most often blamed and least often to blame. A machine that is dead, resetting, or ignoring half its own panel usually has a supply problem, a failed sensor or a connector that has corroded in this humidity — and all three imitate a failed board convincingly. We measure what reaches the board before quoting one, because on this badge a board is frequently a large share of what the appliance is now worth.
- From $89 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
Before you read on
What this job costs and how it is agreed
A starting figure, not a quote. What moves it is the model, how the unit is built in and which part it needs — settled after the on-site diagnostic.
Starts at
from $245
After a diagnostic from $89, which comes off the bill when you go ahead.
or call (305) 615-5496
Diagnostic
From $89, credited to the repair
The price
In writing, before anything is opened
Warranty
On the labor we performed
On the visit
How this visit actually goes
The same order every time, so nothing is opened and nothing is charged before you have seen the figure and said yes.
-
01
Confirm what arrives at the board
Both legs on a 240-volt appliance, the neutral, the low-voltage supply. A machine on one leg behaves like a machine with a broken brain.
-
02
Check the connectors, not just the board
In this climate the pins go green before the electronics fail. A connector cleaned and reseated has ended more of these calls than any part fitted.
-
03
Read the sensors the board is reading
A thermistor that reports nonsense makes the board act insanely and test perfectly.
-
04
Only then price the board
With the part number from the plate, because these boards are model-specific and a near match is not a match.
-
05
Say what the machine is worth
Where the board is most of the price of a replacement appliance, that is said before the order is placed, not after.
Applies to
The Frigidaire units we carry this work out on
-
Top freezer · French door · side by side Frigidaire refrigerator repair in Miami
The deepest branch of this catalog by a distance: 142 cabinets, and the largest single family in everything Frigidaire currently sells is the plain top-freezer refrigerator — 55 of them. That number is the brand in one line. This is the refrigerator that came with the apartment, and half our calls are for a cabinet nobody chose. French door adds 44 and side-by-side 31, which is where the ice and water go wrong, and the two-cabinet compact and bottom-freezer families are small enough to name individually. In this climate the work concentrates on defrost, on door seals that never fully dry, and on condensers that live in salt air.
- 142 cabinets across five layouts — top freezer is the biggest family in the catalog
- French door and side-by-side bring the ice and water circuits most calls are about
- Defrost, seals and condensers do most of the failing in South Florida
-
Upright · chest · single door Frigidaire freezer repair in Miami
Twenty-seven cabinets, and unusually for a volume brand the upright is the bigger half — 17 against three chest freezers and a small single-door family. In South Florida a standalone freezer usually lives in a garage or a utility room rather than a kitchen, which changes both what goes wrong and what a visit involves: ambient temperature well above what the cabinet was rated for, a condenser breathing dust, and a door that gets opened with wet hands in August. A freezer that is quietly running warm is the failure that costs the most, because nothing announces it until the food is gone.
- 27 cabinets — 17 upright, three chest, the rest single-door
- Most of them live in a garage, at an ambient the cabinet was never rated for
- Running warm is the expensive failure: nothing tells you until the food does
-
Built-in · front control · plastic and stainless tub Frigidaire dishwasher repair in Miami
Thirty-six machines, from the plain front-control model that fills a builder's kitchen to the Gallery and Professional trims with a third rack. This is the appliance where the difference between series is smallest: the same platform, a different fascia and a quieter tub. What we attend is consistent because of that — not draining, not cleaning, not drying, and water where it should not be. The filter and the spray arms account for more of it than any electrical part does, which is why the first questions are about what is at the bottom of the tub.
- 36 machines across three trims on much the same platform
- Not draining, not cleaning, not drying, leaking — four complaints, one machine
- The filter and the spray arms explain more calls than any board ever does
-
Top load · front load · laundry centers Frigidaire washer repair in Miami
The current catalog carries two top-load washers and three laundry centers, and that thinness is worth saying out loud: Frigidaire's laundry line today is a fraction of its kitchen line. What we open in South Florida is mostly older — front-loaders from the years the badge sold them in volume, top-loaders in condominium closets, and stacked laundry centers in apartments where nothing else fits. The failures are the ones that come with age and with this climate: bearings, seals that never dry, pumps that meet a lint load nobody clears, and drains that back up in a shared stack.
- Nine current laundry machines in the whole catalog — two of them washers
- Most of what we service is older, and stacked centers are normal in condominiums
- Bearings, door seals, pumps and shared drains do the failing here
-
Electric · gas · stacked centers Frigidaire dryer repair in Miami
Four dryers and three laundry centers in the current line, and every one of them vented — there is no heat-pump dryer under this badge. In South Florida the vent is most of the story: a duct that runs further than it should, through a wall into a corridor or up through a building, collecting lint at every bend. A dryer that takes two cycles to dry a load is almost never a broken dryer, and saying so before selling a part is the difference between a repair and a sale. The genuine problems, when they come, are the element or the burner, the thermostat and the cutout, the drum rollers and the belt.
- Every dryer here is vented — no heat-pump machine under this badge
- Long duct runs and lint explain more slow-drying calls than any part does
- Element or burner, cutouts, rollers and belt are the real failures
-
Single · double · microwave combination Frigidaire oven repair in Miami
Fifty wall ovens: 24 single, 16 double and ten microwave combinations. Unlike the freestanding range, these are built into a cabinet column, and that changes the job before anyone touches the appliance — the oven has to come out on its runners to be worked on, the cabinet has to take the weight, and on a double oven the upper cavity is at head height. The problems themselves are the familiar ones: heating, the sensor and calibration, the door and its hinges, and the lock that has to release before the door will open.
- 50 cavities — 24 single, 16 double, ten microwave combinations
- Built into a column, so access is planned before the visit rather than found
- Heating, sensor and calibration, door hinges and the lock
-
Electric · gas · induction · dual fuel Frigidaire range repair in Miami
Eighty ranges, and all four fuels: 35 electric, 31 gas, 12 induction and two dual-fuel. That induction figure matters — this is not a make where the technology is absent, and a page or a photograph that pretended otherwise would be wrong about the catalog. The freestanding range is what most Frigidaire kitchens have, which means the appliance can be pulled out, the service access is decent and the parts channel is wide. What we attend divides cleanly: the cooking surface, the oven cavity, and the control that runs both.
- 80 ranges across electric, gas, induction and dual fuel
- Induction is genuinely part of this catalog — 12 ranges
- Freestanding means real service access and a wide parts channel
-
Gas · electric radiant · induction Frigidaire cooktop repair in Miami
Thirty-one cooktops, near enough evenly split: 12 gas, 11 electric radiant and eight induction. Dropped into a worktop, they are the appliance most likely to be damaged by something other than a problem — a cracked ceramic top from a dropped pan, a spill that has reached the switches, a burner cap put back wrong after a clean. The genuine failures are the elements and their switches on radiant, the igniters and valves on gas, and the coils, fans and power board on induction.
- 31 cooktops — 12 gas, 11 radiant, eight induction
- Cracked glass and spills into the switchgear are as common as real problems
- Induction is one third of the line and is repaired quite differently
In more detail
About Frigidaire control board repair
The part most often blamed and least often guilty
A board is what people arrive at when a machine does something unaccountable, and on this badge it is usually the wrong answer. The platform underneath the three trim levels is a simple one — thermostats, switches, timers and a relay or two doing work that a more expensive make gives to electronics — so the first hour goes on proving the supply, the switch and the harness before anything is condemned. When the board really has failed, it shows: scorching, a swollen capacitor, a relay that will not pull in with the coil energized.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about Frigidaire control board repair
The repair shop told me it is the board. Do you check that again?
We do, every time, and not out of scepticism. A board is condemned by exclusion, so it is only as good as what was excluded — and a harness rubbed through behind a cabinet reads exactly like a dead output until somebody puts a meter on it.
Are boards for these still available?
For current and recent platforms yes, and this badge has the widest parts channel we work with. On genuinely old machines a board can be the point where a repair stops making sense, and we say so before ordering rather than after.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name